About the service
I design and build complete basement wet bar setups that center on a plumbed draft beer tap system, turning an unused corner of a basement into a real entertaining hub. The work starts with a short consultation where we walk the space, talk through how you plan to use the bar, and settle on a layout that fits the footprint, the existing plumbing runs, and any structural posts or ductwork already in the room. From there I put together a scaled drawing showing the bar counter, back bar cabinetry, sink location, and the recessed or built-in compartment sized for a compact keg cooling unit and its tap tower.
On the construction side I frame and box out the bar counter and lower cabinets from moisture-resistant framing material, then panel and trim the exterior faces to match the rest of the finished basement, whether that means painted shaker doors, a wood veneer, or a simpler laminate finish for a tighter budget. A durable countertop is templated and set on top, cut and sealed around the sink bowl and any tap tower mounting holes. Rough plumbing for a small bar sink is tied into the nearest supply and drain lines, with a dedicated shutoff added so the fixture can be serviced without touching the rest of the house system, and a vented drain trap is installed to keep the space odor free.
The tap system itself is the part I pay closest attention to. I build out the insulated cabinet cavity sized to the cooling unit you choose, run the beer line and gas line cleanly through the counter to the tower, and mount the tower securely on the finished top so it sits level and free of wobble. All tubing is secured, labeled, and kept accessible behind a removable panel for future cleaning or line changes, and I test pour and check for leaks at every connection before calling the job finished. A dedicated grounded outlet is coordinated for the cooling unit, along with task lighting under the upper cabinets or shelving so the pour area is well lit.
Every project wraps up with a full walkthrough covering how to clean the beer lines, how to swap a keg, and basic troubleshooting if the pour runs foamy. I also leave you with care notes for the countertop and cabinet finishes. I can work from your own sketch or start from a blank basement, and I am happy to coordinate with a plumber or electrician you already have, or bring in trusted trade partners for any work outside general carpentry and finish work. Message me with your basement dimensions and how many taps you would like, and I will put together a clear scope and timeline before any work begins.
On the construction side I frame and box out the bar counter and lower cabinets from moisture-resistant framing material, then panel and trim the exterior faces to match the rest of the finished basement, whether that means painted shaker doors, a wood veneer, or a simpler laminate finish for a tighter budget. A durable countertop is templated and set on top, cut and sealed around the sink bowl and any tap tower mounting holes. Rough plumbing for a small bar sink is tied into the nearest supply and drain lines, with a dedicated shutoff added so the fixture can be serviced without touching the rest of the house system, and a vented drain trap is installed to keep the space odor free.
The tap system itself is the part I pay closest attention to. I build out the insulated cabinet cavity sized to the cooling unit you choose, run the beer line and gas line cleanly through the counter to the tower, and mount the tower securely on the finished top so it sits level and free of wobble. All tubing is secured, labeled, and kept accessible behind a removable panel for future cleaning or line changes, and I test pour and check for leaks at every connection before calling the job finished. A dedicated grounded outlet is coordinated for the cooling unit, along with task lighting under the upper cabinets or shelving so the pour area is well lit.
Every project wraps up with a full walkthrough covering how to clean the beer lines, how to swap a keg, and basic troubleshooting if the pour runs foamy. I also leave you with care notes for the countertop and cabinet finishes. I can work from your own sketch or start from a blank basement, and I am happy to coordinate with a plumber or electrician you already have, or bring in trusted trade partners for any work outside general carpentry and finish work. Message me with your basement dimensions and how many taps you would like, and I will put together a clear scope and timeline before any work begins.
