Project description
This project covers the complete installation of a multi-stage whole-house water filtration and purification system, tied directly into the main water line so that every fixture in the home — kitchen taps, bathroom showers, washing machine, dishwasher, and outdoor spigots — receives treated water from a single point.\n\nThe work begins with a water quality test: hardness, chlorine/chloramine levels, sediment load, iron and manganese content, pH, and, where a private well is involved, bacterial screening. Results determine the exact stage configuration rather than a one-size-fits-all setup. A typical build includes a sediment pre-filter (5–20 micron) to strip sand, rust, and particulate matter; a granular activated carbon (GAC) or catalytic carbon stage to remove chlorine, chloramine, VOCs, and improve taste and odor; and, depending on results, an ultraviolet (UV) disinfection stage rated for the home's peak flow rate to neutralize bacteria and viruses without chemicals. Homes with elevated hardness may also receive a water softener or conditioner ahead of the filtration stack to protect the carbon media and downstream plumbing.\n\nInstallation itself involves shutting off the main supply, cutting into the incoming line after the meter and pressure regulator, mounting a bypass valve assembly so the system can be serviced or bypassed without cutting water to the house, and securing the filter housings to a wall or stand near the point of entry — typically a basement, utility room, or garage. All fittings are pressure-tested for leaks before the main is turned back on, and static and running water pressure are measured before and after installation to confirm no meaningful pressure drop. The UV lamp, if included, is wired to a dedicated outlet with a visual/audible alarm for lamp failure.\n\nBefore handoff, a full system flush removes carbon fines and packaging residue, and a follow-up water test confirms chlorine, sediment, and (if applicable) bacterial counts meet target levels. The homeowner receives a written maintenance schedule: sediment filters typically every 3–6 months, carbon cartridges every 6–12 months, UV lamps annually, and membrane or softener resin per manufacturer specification, along with reminder labels on each housing. The full project, from initial test to final walkthrough, is scoped to complete within the estimated timeframe, including drying and cure time for any soldered or glued fittings.
Other / Miscellaneous Cash, Bank transfer
