Project description
Offering remote work. It is required to perform construction kits CM, CR stage RD.
Object: object OPO (technological unit), grid 2x8x9000 meters, main height +15. Partially to +55.00. The slats are reinforced concrete, the rest metal. In the block equipment, pipes, cable tracks, etc.
The required amount of working documentation:
- development of a set of CM, CM with confirmation of calculations in SCAD software or analogues
3D model development in Tekla Structures
Briefly the main one above.
Based on:
- initial data from the customer - these are the tasks of the subcontractors for the development of CM, KZH, the PD stage, 3D model, etc.
Imagine:
Remote desktop with software (if necessary)
- in rubles. Up to 20% advance, additionally after the closing of the stages and until the final.
- on the basis of the results, further cooperation
- the format of the work is supposed to be removed with the conclusion of an urgent contract. Based on the interim results (negative scenario), a face-to-face visit is necessary with the development of measures to eliminate comments. Extreme measure, quick change of performer. - strict compliance with the terms of the contract between the contractor and the customer. Both ways, of course.
-
We demand a high level of personal responsibility.
It is planned to have a serious amount of work in a short time of 1-1.5 months.
Priorities for descending:
1. Engineer KM, KZH with knowledge of Tekla, ready for the period of work to devote a serious amount of time at the start.
2. Experienced Calculator-Builder (the calculation of the frame m / k, gba, etc.) with design according to the requirements of the customer. SCAD/IDEA Statica/LIRA SAPR, etc.
3. Individual experienced specialists in CM, KZH
4. Ability to work and have experience in lifting 2D drawings in Tekla Structures.
Attention:
We ask you to take seriously the assessment of your strength, the necessary experience, the time to perform this task.
Object: object OPO (technological unit), grid 2x8x9000 meters, main height +15. Partially to +55.00. The slats are reinforced concrete, the rest metal. In the block equipment, pipes, cable tracks, etc.
The required amount of working documentation:
- development of a set of CM, CM with confirmation of calculations in SCAD software or analogues
3D model development in Tekla Structures
Briefly the main one above.
Based on:
- initial data from the customer - these are the tasks of the subcontractors for the development of CM, KZH, the PD stage, 3D model, etc.
Imagine:
Remote desktop with software (if necessary)
- in rubles. Up to 20% advance, additionally after the closing of the stages and until the final.
- on the basis of the results, further cooperation
- the format of the work is supposed to be removed with the conclusion of an urgent contract. Based on the interim results (negative scenario), a face-to-face visit is necessary with the development of measures to eliminate comments. Extreme measure, quick change of performer. - strict compliance with the terms of the contract between the contractor and the customer. Both ways, of course.
-
We demand a high level of personal responsibility.
It is planned to have a serious amount of work in a short time of 1-1.5 months.
Priorities for descending:
1. Engineer KM, KZH with knowledge of Tekla, ready for the period of work to devote a serious amount of time at the start.
2. Experienced Calculator-Builder (the calculation of the frame m / k, gba, etc.) with design according to the requirements of the customer. SCAD/IDEA Statica/LIRA SAPR, etc.
3. Individual experienced specialists in CM, KZH
4. Ability to work and have experience in lifting 2D drawings in Tekla Structures.
Attention:
We ask you to take seriously the assessment of your strength, the necessary experience, the time to perform this task.
Engineering. Drawings Cash, Bank transfer
