About the service
With over a decade of hands-on experience pouring concrete outdoor steps for homes and commercial entries, I offer a complete contractor service from initial site assessment through final cure.
Every staircase is engineered to meet local building code: riser heights held to a consistent 7 inches, tread depth no less than 11 inches, and a maximum variance of 3/8 inch between any two steps in the same flight — the single most common cause of trip-and-fall claims on outdoor concrete stairs.
I build custom wooden forms on site, plumb and braced against frost heave, then tie a full rebar reinforcement grid (typically #3 or #4 rebar on 12-inch centers, doubled at the nosing edge) before any concrete goes in, so the finished steps resist cracking through freeze-thaw cycles for decades rather than years.
Concrete is placed in a single continuous pour wherever the flight allows, vibrated to eliminate honeycombing, and finished with a broom texture applied at the correct moisture window — deep enough to give real slip resistance in rain or snow, not just a cosmetic pass.
Where a handrail is required by code or requested by the client, I set anchor bolts or post sleeves directly into the wet concrete at the specified layout, embedded to the depth the hardware manufacturer calls for, so the rail never wobbles or pulls loose the way surface-mounted brackets do on older installs.
I also handle integral color, exposed-aggregate accents, and drainage detailing so water sheds off the tread and away from the foundation instead of pooling and refreezing.
Typical turnaround for a residential entry staircase, from signed estimate to stripped forms, is five to seven working days including cure time before foot traffic; commercial or multi-flight jobs are quoted with a written schedule up front. I bring my own forming lumber, rebar, vibrator, and finishing tools, and I clean the site of forms, spoil, and debris before final walkthrough. References and photos of completed staircases — including code inspection sign-offs — are available on request.
Every staircase is engineered to meet local building code: riser heights held to a consistent 7 inches, tread depth no less than 11 inches, and a maximum variance of 3/8 inch between any two steps in the same flight — the single most common cause of trip-and-fall claims on outdoor concrete stairs.
I build custom wooden forms on site, plumb and braced against frost heave, then tie a full rebar reinforcement grid (typically #3 or #4 rebar on 12-inch centers, doubled at the nosing edge) before any concrete goes in, so the finished steps resist cracking through freeze-thaw cycles for decades rather than years.
Concrete is placed in a single continuous pour wherever the flight allows, vibrated to eliminate honeycombing, and finished with a broom texture applied at the correct moisture window — deep enough to give real slip resistance in rain or snow, not just a cosmetic pass.
Where a handrail is required by code or requested by the client, I set anchor bolts or post sleeves directly into the wet concrete at the specified layout, embedded to the depth the hardware manufacturer calls for, so the rail never wobbles or pulls loose the way surface-mounted brackets do on older installs.
I also handle integral color, exposed-aggregate accents, and drainage detailing so water sheds off the tread and away from the foundation instead of pooling and refreezing.
Typical turnaround for a residential entry staircase, from signed estimate to stripped forms, is five to seven working days including cure time before foot traffic; commercial or multi-flight jobs are quoted with a written schedule up front. I bring my own forming lumber, rebar, vibrator, and finishing tools, and I clean the site of forms, spoil, and debris before final walkthrough. References and photos of completed staircases — including code inspection sign-offs — are available on request.
