About the service
Pool decks demand covers that glide true on the first pass and every pass after. My service focuses on automatic safety cover installation from start to finish: laying out track rail runs flush along the coping so the fabric tracks without binding, anchoring brass deck sleeves to spec, and setting the motor housing in a weatherproof vault box with proper drainage clearance.
Every cover I install uses mesh or solid vinyl rated for child and pet safety load standards, and I keep a documented portfolio of weight-bearing test results from past installations so owners can verify the rating before final payment. Control setup includes a keyed wall switch plus an optional remote or smartphone relay, wired through a GFCI-protected circuit with a lockout override for service technicians.
Typical turnaround is five to seven working days from site survey to final walkthrough: day one is measuring and ordering the track and fabric to exact pool geometry, days two through four are rail mounting and housing installation, and the final day is motor calibration, safety-edge testing, and a load demonstration with sandbags before I hand over the switch keys. I also retrofit rail systems onto existing pools with irregular coping, splice rails around raised spas, and repair bent track or slipped fabric on covers I did not originally install. References and photos of anchor patterns, vault box wiring, and completed installs are available on request.
Every cover I install uses mesh or solid vinyl rated for child and pet safety load standards, and I keep a documented portfolio of weight-bearing test results from past installations so owners can verify the rating before final payment. Control setup includes a keyed wall switch plus an optional remote or smartphone relay, wired through a GFCI-protected circuit with a lockout override for service technicians.
Typical turnaround is five to seven working days from site survey to final walkthrough: day one is measuring and ordering the track and fabric to exact pool geometry, days two through four are rail mounting and housing installation, and the final day is motor calibration, safety-edge testing, and a load demonstration with sandbags before I hand over the switch keys. I also retrofit rail systems onto existing pools with irregular coping, splice rails around raised spas, and repair bent track or slipped fabric on covers I did not originally install. References and photos of anchor patterns, vault box wiring, and completed installs are available on request.
