About the service
Every spring and fall, a swimming pool needs a careful hand-off between the swimming season and the off-season, and doing it wrong costs far more than doing it right. I offer a complete seasonal pool opening and closing service built around the two moments that matter most: the day the cover comes off and the day the water goes quiet for winter.
Opening starts with safe cover removal and cleanup — draining standing water off a mesh or solid cover without dumping debris and algae into the pool, then a full skim, brush, and vacuum pass before a single chemical goes in. From there I run a complete water test (chlorine or salt, pH, alkalinity, calcium hardness, stabilizer) and bring the chemistry into balance in stages rather than all at once, so shock treatment does not fight against startup sanitizer. Pump, filter, and heater get inspected, primed, and restarted, with attention to o-rings, unions, and any component that sat dry all winter.
Closing is where most damage actually happens if it is skipped or rushed. I lower the water level correctly for the plumbing type, blow out lines with a shop vac or compressor rather than trusting antifreeze alone, install winterizing plugs and gizmos in skimmers, and drain pumps, filters, and heaters completely so no trapped water can freeze and crack a housing. A properly balanced winterizing chemical dose goes in before the cover, and the cover itself gets tensioned and checked for tears or sag points that collect water and stress the pool structure.
I work with in-ground and above-ground pools, gunite, vinyl liner, and fiberglass alike, and I document chemical readings and equipment condition at both visits so you have a clear record and a shorter, cheaper opening next season. Scheduling is flexible around your local closing and opening windows, and I explain every step so you understand what your pool actually needs rather than a generic checklist.
Opening starts with safe cover removal and cleanup — draining standing water off a mesh or solid cover without dumping debris and algae into the pool, then a full skim, brush, and vacuum pass before a single chemical goes in. From there I run a complete water test (chlorine or salt, pH, alkalinity, calcium hardness, stabilizer) and bring the chemistry into balance in stages rather than all at once, so shock treatment does not fight against startup sanitizer. Pump, filter, and heater get inspected, primed, and restarted, with attention to o-rings, unions, and any component that sat dry all winter.
Closing is where most damage actually happens if it is skipped or rushed. I lower the water level correctly for the plumbing type, blow out lines with a shop vac or compressor rather than trusting antifreeze alone, install winterizing plugs and gizmos in skimmers, and drain pumps, filters, and heaters completely so no trapped water can freeze and crack a housing. A properly balanced winterizing chemical dose goes in before the cover, and the cover itself gets tensioned and checked for tears or sag points that collect water and stress the pool structure.
I work with in-ground and above-ground pools, gunite, vinyl liner, and fiberglass alike, and I document chemical readings and equipment condition at both visits so you have a clear record and a shorter, cheaper opening next season. Scheduling is flexible around your local closing and opening windows, and I explain every step so you understand what your pool actually needs rather than a generic checklist.
