Projektbeschreibung
The services of a 3D modeling specialist are required. There is a 3D model (stl) axe, need to be improved.
I want to add a hammer and sickle and a notch (engraving) in the place of grab.
The computer is ArtCAM 2009, you need to “pin” everything to it.
Create two halves, UP, under rough processing (frese - galley F12.7X25mm R6.35mm XV 8mm)
And two at the finish (sickle and notch cut) R0.5 * D6 * 30.5 * 75l or R0.25
End passages (bars)
Workpiece ~610mm*~150mm*42mm
I want to add a hammer and sickle and a notch (engraving) in the place of grab.
The computer is ArtCAM 2009, you need to “pin” everything to it.
Create two halves, UP, under rough processing (frese - galley F12.7X25mm R6.35mm XV 8mm)
And two at the finish (sickle and notch cut) R0.5 * D6 * 30.5 * 75l or R0.25
End passages (bars)
Workpiece ~610mm*~150mm*42mm
3D-Grafik Banküberweisung, E-Geld
