Real orders from clients: pick a category, filter by budget and competition, and respond while the project is fresh.
Looking for an HVAC contractor to divide an existing single-zone forced-air system into three independently controlled zones with motorized dampers, a zone control panel, and separ…
Client requests an original copper-foil stained glass panel with a peacock-feather motif for a front-door transom, from cartoon design through finished mounted piece.
Need an experienced hand to replace an aging indoor sauna heater unit, rebuild the cedar benches, and refresh the wall insulation behind the panelling.
Need a licensed contractor to build a walkable rooftop deck over our flat roof, including a structural load check, full waterproof membrane, pedestal paver system, and perimeter ra…
Client project seeking a contractor to build an interlocking block or stone retaining wall on a sloped backyard, complete with gravel drainage backfill and weep holes.
Client project seeking a custom-molded leather saddle cover and hand-stitched handlebar grip wrap for a road bike, made to fit the existing saddle shell and bars.
Seeking a bladesmith to forge a custom high-carbon chef's knife from bar stock, complete with a fitted handle and a wet-molded leather sheath.
Seeking a contractor to frame a shaft and install a small mechanical dumbwaiter with cabin, winch, guide rails, and interlocked doors between my kitchen and basement.
Looking for a leather worker to craft a padded neck strap with quick-release clips for a mirrorless camera, sized and stitched to order.
Looking for an experienced contractor to clean, crack-fill, and sealcoat a residential asphalt driveway before the cold season sets in.
Looking for an experienced mason or oven builder to construct a freestanding, dome-shaped wood-fired brick pizza oven in my backyard, from the base slab through the first cure fire…
Looking for an experienced restorer to re-silver the index and horizon mirrors, fix index arm play, and recalibrate an inherited brass marine sextant. Case repair and a written con…
Need interlocking rubber gym tiles installed over a garage subfloor plus a wall-mounted power rack and pull-up bar bolted into wall studs with proper load-rated anchors.
Seeking a licensed drone pilot to fly transect surveys for wildlife population counts and produce a vegetation habitat map of a protected reserve, with GIS-ready deliverables.
Need a licensed installer to set a gas-fired standby generator on a concrete pad, hook up the gas line, and wire an automatic transfer switch to the main panel.
Looking for a leatherworker to hand-craft a padded guitar strap with custom tooled artwork, adjustable length hardware, and matched end tabs.
Choose a category in the tree, add a search word and open a suitable project. Study the task and send a response with your price and deadline — the client sees every response and chooses the freelancer.
Respond in the first hours after publication and to projects with few responses — the “Fewest responses” sorting shows them first. Show that you understood the task and attach a similar work from your portfolio.
Describe the task specifically, set a budget and a deadline — the project appears in the catalogue and freelancers of the category are notified. Post a project
Projects are also grouped by tags — PHP, WordPress, logos, translations and hundreds of others. Project tags
