1
Дмитрий
no recommendations
no complaints
Project title: Modeling the flow in SolidWorks
Type of cooperation: One-time project
Section: Engineering. Drawings
Prepayment: without prepayment
Payment methods: Bank transfer
Acceptance of requests: from 2022-05-26 until 2022-05-31
Type of cooperation: One-time project
Section: Engineering. Drawings
Prepayment: without prepayment
Payment methods: Bank transfer
Acceptance of requests: from 2022-05-26 until 2022-05-31
Project description:
We need a specialist in the SolidWorks program. It requires flow modeling in SolidWorks.
The medium is Freon 507a gas.
Entrance downtown. Two exits at the edges of 50x50%, as well as 12x50% by flow.
Total flow of 2.75kg/sec. Temperature is -35C. There is a dispersed oil in the stream - 1%.
It is necessary to simulate the behavior of droplets of 0.5 mm and 1 mm.
The design of the device should delay drops from hitting the output holes.
According to the results of the simulation, it is possible to adjust the product.
We need a specialist in the SolidWorks program. It requires flow modeling in SolidWorks.
The medium is Freon 507a gas.
Entrance downtown. Two exits at the edges of 50x50%, as well as 12x50% by flow.
Total flow of 2.75kg/sec. Temperature is -35C. There is a dispersed oil in the stream - 1%.
It is necessary to simulate the behavior of droplets of 0.5 mm and 1 mm.
The design of the device should delay drops from hitting the output holes.
According to the results of the simulation, it is possible to adjust the product.
