Modeling the flow in SolidWorks
Employer
[no-member:pro]Dmitry[/no-member:pro]
Project parameters
Type of cooperationOne-time project
SectionEngineering. Drawings
Prepaymentwithout prepayment
Payment methodsBank transfer
Acceptance of requestsfrom May 26, 2022 until May 31, 2022
Project description
We need a specialist in the SolidWorks program. It requires flow modeling in SolidWorks.
The medium is Freon 507a gas.
Entrance downtown. Two exits at the edges of 50x50%, as well as 12x50% by flow.
Total flow of 2.75kg/sec. Temperature is -35C. There is a dispersed oil in the stream - 1%.
It is necessary to simulate the behavior of droplets of 0.5 mm and 1 mm.
The design of the device should delay drops from hitting the output holes.
According to the results of the simulation, it is possible to adjust the product.
The medium is Freon 507a gas.
Entrance downtown. Two exits at the edges of 50x50%, as well as 12x50% by flow.
Total flow of 2.75kg/sec. Temperature is -35C. There is a dispersed oil in the stream - 1%.
It is necessary to simulate the behavior of droplets of 0.5 mm and 1 mm.
The design of the device should delay drops from hitting the output holes.
According to the results of the simulation, it is possible to adjust the product.
