1
Михаил
no recommendations
no complaints
Project title: Auto-watering system
Type of cooperation: One-time project
Section: Software development
Prepayment: without prepayment
Payment methods: Bank transfer, Electronic money
Acceptance of requests: from 2021-08-18 until 2021-08-25
Type of cooperation: One-time project
Section: Software development
Prepayment: without prepayment
Payment methods: Bank transfer, Electronic money
Acceptance of requests: from 2021-08-18 until 2021-08-25
Project description:
We need to refine the existing sketch.
1. Remove the servo drive control
2 add watering control using gsm gprs sim 800 module
3. Control via SMS team
Status - information about the irrigation zone and temperature
On (zone number) (time in mines) - inclusion of the specified zone at the specified time
Off (zone number) - deactivate the specified zone
Off-off-off-off all zones.
Also you need to implement a "smooth transition of watering" i.e. the transition from one zone to another zone should occur as follows: 1 on 2 off, 1 on 2 on, 1 off 2 on. This is to avoid a water shock. Only 1 zone can operate. It's 4 zones. Each zone is 1 exit on the relay. Correspondingly, the relay is off-water. Of the sensors, only rtc, temperature and humidity and a rain sensor are used. All sensors are like a project. Version used 1.3.3
We need to refine the existing sketch.
1. Remove the servo drive control
2 add watering control using gsm gprs sim 800 module
3. Control via SMS team
Status - information about the irrigation zone and temperature
On (zone number) (time in mines) - inclusion of the specified zone at the specified time
Off (zone number) - deactivate the specified zone
Off-off-off-off all zones.
Also you need to implement a "smooth transition of watering" i.e. the transition from one zone to another zone should occur as follows: 1 on 2 off, 1 on 2 on, 1 off 2 on. This is to avoid a water shock. Only 1 zone can operate. It's 4 zones. Each zone is 1 exit on the relay. Correspondingly, the relay is off-water. Of the sensors, only rtc, temperature and humidity and a rain sensor are used. All sensors are like a project. Version used 1.3.3
