Building an assembly in SolidWorks
Employer
[no-member:pro]Liliya[/no-member:pro]
Project parameters
Type of cooperationOne-time project
Section3D graphics
Prepaymentwithout prepayment
Payment methodsBank transfer
Acceptance of requestsfrom Jun 18, 2022 until Jun 28, 2022
Project description
We need a specialist in SolidWorks. It is necessary in SolidWorks to create the main parts of the docking unit and assembly. File attached. The model can be simplified. Necessary elements: the main ring, the lower frame, latches around the perimeter of the ring, the tightening devices can be represented in the form of cylinders, upper frame, trapezoidal guides, springs, fastening elements of these parts.
Principal dimensions:
Main ring: External diameter 1255 mm, internal diameter 1045 mm.
Lower frame: External diameter 1045 mm, internal diameter 1000 mm.
Top frame: External diameter 1045 mm, internal diameter 1000 mm.
The upper frame must be moved into the lower. Extremity 200 mm up.
The diameter between the guides is 800 mm.
The rest of the sizes are taken approximately from the ratio of the model.
Principal dimensions:
Main ring: External diameter 1255 mm, internal diameter 1045 mm.
Lower frame: External diameter 1045 mm, internal diameter 1000 mm.
Top frame: External diameter 1045 mm, internal diameter 1000 mm.
The upper frame must be moved into the lower. Extremity 200 mm up.
The diameter between the guides is 800 mm.
The rest of the sizes are taken approximately from the ratio of the model.
