Programming of the PLC Siemens S7-1200
Employer
[no-member:pro]Sergey[/no-member:pro]
Project parameters
Type of cooperationOne-time project
SectionSoftware development
Prepaymentwithout prepayment
Payment methodsBank transfer, Electronic money
Acceptance of requestsfrom Feb 26, 2022 until Mar 3, 2022
Project description
Programmer services are required. You need to create a program for the Siemens S7-1200 PLC using the SCL and LAD programming language, which will control the lighting of the building.
The requirements are as follows:
• 3 floors.
• When pressing the switch, it must turn on the lighting of the floor on which it was pressed.
• The lights remain on for 10 minutes.
• Lights on each floor can only be turned on 100 times a day.
Lights can only be turned on at night (use a light sensor)
• Day to day (every 24 hours) discharge 100 times.
• A maintenance switch (floor cleaning) that turns on light on all floors but does not count 100 times.
• Once you reach the switch limit 100 times a day, the lights should not be turned on.
• During the daytime, the light shall not be lit when the switch is pressed.
The requirements are as follows:
• 3 floors.
• When pressing the switch, it must turn on the lighting of the floor on which it was pressed.
• The lights remain on for 10 minutes.
• Lights on each floor can only be turned on 100 times a day.
Lights can only be turned on at night (use a light sensor)
• Day to day (every 24 hours) discharge 100 times.
• A maintenance switch (floor cleaning) that turns on light on all floors but does not count 100 times.
• Once you reach the switch limit 100 times a day, the lights should not be turned on.
• During the daytime, the light shall not be lit when the switch is pressed.
