Improvement of the 3D model of the axe
Employer
AndreyAndrey
Project parameters
Type of cooperationPeriodic employment
Section3D graphics
Prepaymentprepayment is possible
Payment methodsBank transfer, Electronic money
Acceptance of requestsclosed
Project description
The services of a 3D modeling specialist are required. There is a 3D model (stl) axe, need to be improved.
I want to add a hammer and sickle and a notch (engraving) in the place of grab.
The computer is ArtCAM 2009, you need to “pin” everything to it.
Create two halves, UP, under rough processing (frese - galley F12.7X25mm R6.35mm XV 8mm)
And two at the finish (sickle and notch cut) R0.5 * D6 * 30.5 * 75l or R0.25
End passages (bars)
Workpiece ~610mm*~150mm*42mm
I want to add a hammer and sickle and a notch (engraving) in the place of grab.
The computer is ArtCAM 2009, you need to “pin” everything to it.
Create two halves, UP, under rough processing (frese - galley F12.7X25mm R6.35mm XV 8mm)
And two at the finish (sickle and notch cut) R0.5 * D6 * 30.5 * 75l or R0.25
End passages (bars)
Workpiece ~610mm*~150mm*42mm
