1
Лариса
no recommendations
no complaints
Project title: Make tasks on descriptive geometry
Type of cooperation: One-time project
Section: Education and consulting
Prepayment: prepayment is possible
Payment methods: Bank transfer
Acceptance of requests: from 2023-04-13 until 2023-04-18
Type of cooperation: One-time project
Section: Education and consulting
Prepayment: prepayment is possible
Payment methods: Bank transfer
Acceptance of requests: from 2023-04-13 until 2023-04-18
Project description:
The services of a specialist in descriptive geometry are required. Online work on descriptive geometry 3 tasks for 1 hour 30 minutes. 30 minutes per mission. During this time, perform on A4, take a picture, translate to PDF, send. We get the following assignment, etc.
The test is next week, there is no exact date yet.
The tasks from the previous standings are presented
1.Task In the form of a scale, build a contour plan of the plane β with a 70% slope and a contour plan of the plane ε, inclined at an angle of 60 ° to the horizontal (modules should be applied).
The planes should be assumed so that the line k is the boundary between the planes intended.
Block j = 2.5 cm (use the dimensional line to indicate the installation locations of the block). Draw the tilt lines of the planes. The k-line module is 8 cm.
The services of a specialist in descriptive geometry are required. Online work on descriptive geometry 3 tasks for 1 hour 30 minutes. 30 minutes per mission. During this time, perform on A4, take a picture, translate to PDF, send. We get the following assignment, etc.
The test is next week, there is no exact date yet.
The tasks from the previous standings are presented
1.Task In the form of a scale, build a contour plan of the plane β with a 70% slope and a contour plan of the plane ε, inclined at an angle of 60 ° to the horizontal (modules should be applied).
The planes should be assumed so that the line k is the boundary between the planes intended.
Block j = 2.5 cm (use the dimensional line to indicate the installation locations of the block). Draw the tilt lines of the planes. The k-line module is 8 cm.
Attached files:
Attached files are available only to Freelancers and the project author
Attached files are available only to Freelancers and the project author
