1
Ден
no recommendations
no complaints
Project title: Modeling in SolidWorks
Type of cooperation: One-time project
Section: 3D graphics
Prepayment: prepayment is possible
Payment methods: Bank transfer
Acceptance of requests: from 2022-06-17 until 2022-06-27
Type of cooperation: One-time project
Section: 3D graphics
Prepayment: prepayment is possible
Payment methods: Bank transfer
Acceptance of requests: from 2022-06-17 until 2022-06-27
Project description:
Good evening. The services of a modeling specialist in SolidWorks are required. We need to make one machine, it needs to be modified to real conditions.
The interior of the underwater vehicle is not important, most importantly its corpus-mechanical part.
We'll have to purge.
Show the strength of the attachment of the screws of the skin.
The device should be deep-sea, there should be good drag. Good skis are needed so that the device can get to the bottom and not fall into the silt.
Calculation of the strength of the shell,
Pressure, Calculation for the stability of the body between rigid supports.
As I understand it, most of the work is calculated by the program - what maximum depth can be immersed in the machine.
Make a few structural schemes.
Maximum load on the machine and mine. Under water.
Change the location of the screws and show how it will be better and worse for the streamlined body and the operation of the screws. And how to arrange the screws as best as possible.
Is it possible to do that?
Good evening. The services of a modeling specialist in SolidWorks are required. We need to make one machine, it needs to be modified to real conditions.
The interior of the underwater vehicle is not important, most importantly its corpus-mechanical part.
We'll have to purge.
Show the strength of the attachment of the screws of the skin.
The device should be deep-sea, there should be good drag. Good skis are needed so that the device can get to the bottom and not fall into the silt.
Calculation of the strength of the shell,
Pressure, Calculation for the stability of the body between rigid supports.
As I understand it, most of the work is calculated by the program - what maximum depth can be immersed in the machine.
Make a few structural schemes.
Maximum load on the machine and mine. Under water.
Change the location of the screws and show how it will be better and worse for the streamlined body and the operation of the screws. And how to arrange the screws as best as possible.
Is it possible to do that?
