2
Юрий
no recommendations
no complaints
Project title: Write a sketch of Arduino
Type of cooperation: Periodic employment
Section: Software development
Prepayment: prepayment is possible
Payment methods: Bank transfer
Acceptance of requests: from 2022-02-07 until 2022-02-22
Type of cooperation: Periodic employment
Section: Software development
Prepayment: prepayment is possible
Payment methods: Bank transfer
Acceptance of requests: from 2022-02-07 until 2022-02-22
Project description:
Offering additional income for the programmer. The services of a Sketch Arduino writing specialist are required. I need a sketch by Arduino Nano.
Rotate 2 step nema17 drivers A4988. Approximately 1 rotation per second.
DIR, ENABLE and division of step 1/16 on the driver are physically sealed, only STEP is used.
The second step rotates slower than the first, about 2 times, the division coefficient is set in SETUP.
The speed of the first and, accordingly, the second engines is regulated by a potentiometer, the min mach is installed in SETUP.
After making N steps, approximately 6-10 turns of the first engine, there is a pause in the rotation of the engines, for 0.2-2 seconds.
N steps are set by a potentiometer, min mach is installed in SETUP.
The pause time is set by a potentiometer, the min mach is set in SETUP.
During a pause on one of the outputs of the arduino, a log 1 signal is issued.
Between taking N steps in step X to a separate output of the arduino, a log 1 signal is issued for a duration of 0.2-1 sec, this time is set in SETUP, while the engines continue to rotate, the duration of this signal does not depend on other processes.
The number of steps X is determined by a potentiometer and never exceeds N. Through MAP.
After a pause, the process is repeated.
Offering additional income for the programmer. The services of a Sketch Arduino writing specialist are required. I need a sketch by Arduino Nano.
Rotate 2 step nema17 drivers A4988. Approximately 1 rotation per second.
DIR, ENABLE and division of step 1/16 on the driver are physically sealed, only STEP is used.
The second step rotates slower than the first, about 2 times, the division coefficient is set in SETUP.
The speed of the first and, accordingly, the second engines is regulated by a potentiometer, the min mach is installed in SETUP.
After making N steps, approximately 6-10 turns of the first engine, there is a pause in the rotation of the engines, for 0.2-2 seconds.
N steps are set by a potentiometer, min mach is installed in SETUP.
The pause time is set by a potentiometer, the min mach is set in SETUP.
During a pause on one of the outputs of the arduino, a log 1 signal is issued.
Between taking N steps in step X to a separate output of the arduino, a log 1 signal is issued for a duration of 0.2-1 sec, this time is set in SETUP, while the engines continue to rotate, the duration of this signal does not depend on other processes.
The number of steps X is determined by a potentiometer and never exceeds N. Through MAP.
After a pause, the process is repeated.
