1
Максим
no recommendations
no complaints
Project title: Collect a fee in P-CAD
Type of cooperation: One-time project
Section: Engineering. Drawings
Prepayment: prepayment is possible
Payment methods: Bank transfer
Acceptance of requests: from 2021-09-11 until 2021-09-07
Type of cooperation: One-time project
Section: Engineering. Drawings
Prepayment: prepayment is possible
Payment methods: Bank transfer
Acceptance of requests: from 2021-09-11 until 2021-09-07
Project description:
Offering extra earnings. You need to collect a fee in P-CAD.
Important point - everything (element sizes, symbols, sizes of holes and contact platforms, etc.) should be calculated according to GOST what you need to do: 1) Make a library of elements that are needed in the scheme (in SimbolEditor - images of elements, in PatternEditor - contact platforms). The exact names and types of elements are at the end of the file "Management device" 2 Collect the schema itself (it will also be in the attached file "Management device") in AddScematic 3 Create a board in PCB (the dimensions are in the file at the end), make metallization and save all files. 4) to draw up a schematic diagram and indicate ways of attaching elements to the board according to GOST (see the example in the attached) 5) to give recommendations on increasing the coefficient of technology of the printed circuit board, it is not necessary to go into the calculations (the example of calculation will be in the attached) 6) to send all the files to me (the library of elements, the scheme, netlist, metallized board and everything else that will be)
Offering extra earnings. You need to collect a fee in P-CAD.
Important point - everything (element sizes, symbols, sizes of holes and contact platforms, etc.) should be calculated according to GOST what you need to do: 1) Make a library of elements that are needed in the scheme (in SimbolEditor - images of elements, in PatternEditor - contact platforms). The exact names and types of elements are at the end of the file "Management device" 2 Collect the schema itself (it will also be in the attached file "Management device") in AddScematic 3 Create a board in PCB (the dimensions are in the file at the end), make metallization and save all files. 4) to draw up a schematic diagram and indicate ways of attaching elements to the board according to GOST (see the example in the attached) 5) to give recommendations on increasing the coefficient of technology of the printed circuit board, it is not necessary to go into the calculations (the example of calculation will be in the attached) 6) to send all the files to me (the library of elements, the scheme, netlist, metallized board and everything else that will be)
