1
Евгений
no recommendations
no complaints
Closed
Project title: I am looking for a programmer – management of Arduino with PC
Type of cooperation: One-time project
Section: Software development
Prepayment: prepayment is possible
Payment methods: Cash, Bank transfer
Acceptance of requests: closed
Type of cooperation: One-time project
Section: Software development
Prepayment: prepayment is possible
Payment methods: Cash, Bank transfer
Acceptance of requests: closed
Project description:
Good afternoon!
You need to write a program to control Arduino commands from a PC (with a simple interface) to devices (modules connected to it) and receive signals from sensors. The teams themselves, respectively.
Who can take it (for the money)?
The cost, you name it.
I'm in Moscow. Therefore, it is desirable that the person was in Moscow or the suburbs.
What is and will be connected:
To the controller (Arduino UNO), through the expansion card, 2 servo drives (by 180 °), 3 relays (single-channel relays of 5 V modules by 10A will be connected. They will be connected to the lamps for 220V) and 3 sensors (mechanical, optical and temperature). All modules and sensors with external (independent) power supply, including the controller (from the power supply). All devices (modules) on the hands (bought).
There is also a connection plan (but I would like to know your opinion on this too, because it is a good idea to do so). I have written it based on the recommendations in various articles.
I would like you to draw a picture too, so as not to refer to mine!
Technical assignment prepared.
The test plan is also prepared.
Good afternoon!
You need to write a program to control Arduino commands from a PC (with a simple interface) to devices (modules connected to it) and receive signals from sensors. The teams themselves, respectively.
Who can take it (for the money)?
The cost, you name it.
I'm in Moscow. Therefore, it is desirable that the person was in Moscow or the suburbs.
What is and will be connected:
To the controller (Arduino UNO), through the expansion card, 2 servo drives (by 180 °), 3 relays (single-channel relays of 5 V modules by 10A will be connected. They will be connected to the lamps for 220V) and 3 sensors (mechanical, optical and temperature). All modules and sensors with external (independent) power supply, including the controller (from the power supply). All devices (modules) on the hands (bought).
There is also a connection plan (but I would like to know your opinion on this too, because it is a good idea to do so). I have written it based on the recommendations in various articles.
I would like you to draw a picture too, so as not to refer to mine!
Technical assignment prepared.
The test plan is also prepared.
